Medium to bright indirect light. Never direct sunlight.

Let the soil dry between waterings.

No extra humidity required.

Keep this plant consistently in warm temperatures inside with nighttime temperatures decreasing to only 60°F-70°F.

Outside: Grow in dappled shade in morning sun where nights are above 50°F.

Indoors: The Chinese Money Plant enjoys medium to bright, indirect light.

Water the Chinese Money Plant one day prior to fertilizing. Fertilize once a month by diluting a liquid fertilizer by half strength. Let the plant rest in the fall and winter.

When receiving the plant, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes.

Repot in the spring, using a 2" bigger pot to keep the roots drier. (Too big of a pot could cause the soil to dry slower, which is not helpful.) Use a well-draining indoor potting mix with perlite to help with drainage or a cacti and succulent mix. 

Water your plant in the old pot before transferring over and let them sit an hour. Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow it to drain. Add soil to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen. 

Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling. 

Ensure the plant is sitting about 1" below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over. 

Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

To clean the leaves and alleviate dust particles, give it a shower from above. Fill a watering can with filtered, distilled or tap water that has been sitting for 24 hours. Place the plant in a sink and lightly wash the leaves with a shower spray end watering can.

In early spring, take a pilea cutting, use a sharp knife to cut off pinkish red baby offshoots from the main stem.  Remove at least an inch of stalk under the soil leading to the main stem. Be careful not to catch the knife of the healthy leaves on the mother plant. 

If there is no root ball, remove all the soil and place in a vase with water to root. Change the water each week with filtered, bottled or tap water that has been sitting at least 24 hours. 

If there is a root ball, then separate the mother plant from the babies and pot up. Follow the instructions below.*

After 3-4 weeks, check to make sure the stem has well formed roots. If so, it's time to plant. 

*Fill a small container with drainage holes (too large of a container for the cutting will make it difficult to regulate watering needs) using indoor well-draining potting mix such as cacti and succulent mix. 

Mix a little rooting hormone into the soil. Poke a hole in the soil with a pencil. Then, place the cutting in the hole and tamp the soil down around it. 

Water the plant and keep them in medium to bright indirect sunlight. After 4-6 weeks, the roots should be established.

Best in medium light, but can survive in a range of low to high.

Allow the soil to dry out completely between waterings.

Prefers humidity. Spritz occasionally.

Keep this plant out of cold drafts near open windows or doors.

Outside: Keep them in full shade on a patio out of direct sunlight to prevent leaf burn.

Peace lilies are not heavy feeders therefore, every six weeks is sufficient for their nutrient needs. Add a balanced liquid fertilizer to your water and dilute it by half. Fertilize throughout the late winter, early spring and summer months. Note: If your peace lily is not blooming, move them to a brighter area in the house to get indirect sun.

When receiving the plant, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes.

Repot in the spring, using a 2"" bigger pot to keep the roots drier. (Too big of a pot could cause the soil to dry slower, which is not helpful.) Use a well-draining indoor potting mix with perlite to help with drainage.

Water your plant in the old pot before transferring over and let sit an hour. Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow to drain. Add soil to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen.

Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling.

Ensure the plant is sitting about 1"" below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over.

Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

Each time a flower blooms on the peace lily and turns brown, cut the stem off at the base. Prune off any yellowing leaves at the base of the stem. Clean any debris off the soil's surface. To clean, place the plant into a tub or shower. Use a watering can with a shower attachment using distilled, filtered, or water without chlorine or chemicals. Pour the water over the plant to wash away any dust. Do this each quarter to keep your plant's leaves clean.

Propagate and divide your Peace Lily plant in the early spring.

Hydrate the plant the night before.

Pull from the container and brush or wash away the soil carefully around the roots. Carefully divide and repot in rich, indoor peat-based potting soil mix, being aware that each new plant needs at least two or more leaves with sufficient roots attached.

Use a container 2 inches bigger than the root ball with drainage and deep enough for their roots to grow. Place the plant at the same level as the previous pot adding soil at the bottom.

Water the soil and add more soil if settling occurs.

Set them in medium to bright, indirect sunlight while they are rooting.

Check the moisture and humidity each day and add misting to keep the soil moist while the roots establish.

After 6-8 weeks, roots will begin to establish. You can tug onto the stem to ensure the roots are anchoring well.

This plant loves low to medium indirect light.

Allow the soil to dry out completely between waterings.

Pothos love high levels of humidity. Spritz occasionally.

Ideally, the Pothos grows their best when temperatures are between 70°-90°F.

Outside: Grow in full sun (6-8 hours) to partial shade (4-6 hours) where nights are above 60°F.

Indoors: The Golden Pothos prefers bright, indirect light for at least six hours in a southern, eastern and western windows.

Fertilize every two to three months during their growing period in the spring and summer with a balanced liquid fertilizer or topical granular soil fertilizer. Let the plant rest in the fall and winter.

When receiving the plant, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes. Repot in the spring, using a 2" bigger pot to keep the roots drier. (Too big of a pot could cause the soil to dry slower, which is not helpful.) Use a well-draining indoor potting mix with perlite to help with drainage.

Water your plant in the old pot before transferring over and let sit an hour. Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow to drain. Add soil to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen. Inspect the root ball.

Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling. Ensure the plant is sitting about 1" below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over. Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

To clean the leaves and alleviate dust particles: Shower them from above. Fill a watering-can with filtered, distilled, or tap water that has been sitting for 24 hours and is free of chemicals (chlorine or fluoride). Place the plant in a sink and lightly wash the leaves with a shower spray end watering can. Trim off any yellow leaves with sterile scissors. Remove any debris from the soil and replenish soil if needed. Inspect for any insects at this time. Prune the vines up to 2 inches from the soil line to create lushness at the top. As they spills over the rim of the container, trim to maintain their shape and size at your preference. Remove any dried or discolored leaves to keep the plant vigorous.

Stem Cutting: In early spring, take a pothos cutting, use sharp pruners to remove a cutting from a tip off the vine. Cut at least 5-6 inches of stem to propagate. Place in a vase with water to root. Change the water each week with filtered, bottled, or tap water sitting at least 24 hours.

After 3-4 weeks, check to make sure the stem has 1-2 inch, well-formed roots. If so, it's time to plant. *Fill a small container with drainage holes (too large of a container for the cutting will make it challenging to regulate watering needs) using an indoor well-draining potting mix. Mix a little rooting hormone into the soil. Poke a hole in the soil with a pencil. Then, place the cutting in the hole and tamp the soil down around them. Water the plant and keep them in medium to bright indirect sunlight. After 4-6 weeks, the roots should establish.

Division: Divide the Golden Pothos in the early spring when emerging from dormancy. Pull from the container and cut through the roots with a sharp knife or pruners. Repot in a rich, indoor potting soil mix. Use a container 2 inches bigger than the root ball with drainage and is deep enough for the roots to grow. Place the roots at the same level as the previous pot adding soil at the bottom if necessary. Set them in bright, indirect sunlight and water. Check the moisture and humidity each day and add misting to keep the soil moist while the roots establish. After 6-8 weeks, roots will begin to form. You can tug onto the stem to ensure the roots are establishing.

Medium to bright indirect light. Never direct sunlight.

Water thoroughly, but allow them to dry slightly between waterings.

Enjoys high humidity. Spritz occasionally.

Ideally, the Flamingo Flower likes it on average of 68° at night and upwards of 86°F during daylight hours.

Outside: Grow in early morning sun (2-4 hours) where nights are above 60°F.

Indoors: The Flamingo Flower prefers bright, indirect light for at least six hours in a southern, eastern and western windows.

Fertilize once a month during the growing spring and summer with a balanced liquid fertilizer or topical granular soil fertilizer. Let the plant rest in the fall and winter.

Leach salt residue buildup away by flushing the potted plant each month. Let the water run out the drain holes.

When receiving the plant, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes.

Repot in the spring, using a 2" bigger pot to keep the roots drier. (Too big of a pot could cause the soil to dry slower, which is not helpful.) Use a well-draining indoor potting mix with perlite to help with drainage.

Water your plant in the old pot before transferring over and let  sit an hour. Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow to drain. Add soil to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen.

Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling.

Ensure the plant is sitting about 1" below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over.

Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

Gently wipe clean with a soft, damp cloth or paper towel. Work gently from the stem's base toward the leaf's tip, cleaning both sides at once. After cleaning the leaves, remove any dead leaves or debris on the surface of the soil.

Refreshen the soil mixture if needed.

Prune away damaged or diseased leaves or flowers down to the stem base with sterile scissors.

Indoors: Propagate and divide Flamingo Flowers in the early spring when emerging from dormancy.

Pull from the container and brush or wash away the soil carefully. Carefully divide and keep at least two rhizomes together and repot in a rich, indoor potting soil mix.

Use a container that has drainage and is deep enough for the roots to grow. Place the rhizomes at least 1-2 inches down into the soil.

Set in bright, indirect sunlight while they are rooting.

Check the moisture and humidity each day and add misting to keep the soil moist while the roots establish.

After 6-8 weeks, roots will begin to form. You can tug onto the stem to ensure the roots are establishing.

Outdoors: Carefully loosen the soil and dig the tubers up, avoiding damaging the rhizomes. Divide the rhizomes and plant in new locations in your garden. Add rich, damp, and loamy soil in a part-shade morning sun location.